trouble building prints

Post your tips here to help more users.

trouble building prints

Postby Benjamin Beitz » Tue Jun 12, 2018 7:15 pm

I am new to 3d printing and am having trouble with my prints, I cant get the pla to stick to the hot bed. Any suggestions? Also is there another program I can use instead of Xyzware? Maybe one compatible with Autocad inventor?
Benjamin Beitz
New Arrival
Posts: 1
Joined: Tue Jun 12, 2018 6:45 pm

Re: trouble building prints

Postby JeremyT » Mon Aug 27, 2018 5:22 pm

It depends on the printer. I have a Jr. I had the same issue as the bed is not heated. I tried tac build, but found by far the easiest was a stick of Elmer's glue. After the print, I would remove the glass plate with the print and rinse under cold water. The print would pop off, then I cleaned the glass under water. The Jr requires xyzware to print, but you can make the stl with any program.
New Arrival
Posts: 1
Joined: Mon Aug 27, 2018 5:19 pm

Return to Tips & Tutorials

Who is online

Users browsing this forum: No registered users and 1 guest