Print Jobs Won't Stick to Printer Bed

Post any question related to da Vinci series printers here.

Re: Print Jobs Won't Stick to Printer Bed

Postby dbourne » Sat Jan 12, 2019 12:08 pm

jsnake711: Thanks. I'll give that a try. I'm not sure if I can increase the temperature with xyz cartridge but I can try 'other'. I was going lower with the bed temp with mixed success. I don't think I got to 70°C. I've now have blue heat tape for the bed and glue stick but will try adjusting the temperature first. Thanks.
dbourne
Apprentice
 
Posts: 17
Joined: Sun Jan 06, 2019 3:12 pm

Re: Print Jobs Won't Stick to Printer Bed

Postby jsnake711 » Sat Jan 12, 2019 7:20 pm

You can adjust the extruder temp on the printing program it's at the bottom on the first page.
jsnake711
Apprentice
 
Posts: 20
Joined: Wed Dec 26, 2018 5:37 pm

Re: Print Jobs Won't Stick to Printer Bed

Postby dbourne » Mon Jan 14, 2019 9:20 am

jsnake711: Quite right I was able to increase the extruder temperature. +10°C seems good for two models so far. It was bed temperature that maxed out at the default. Thanks
dbourne
Apprentice
 
Posts: 17
Joined: Sun Jan 06, 2019 3:12 pm

Previous

Return to da Vinci Series

Who is online

Users browsing this forum: No registered users and 2 guests