Printer not detecting wifi

General 3D printing related questions, post here!

Printer not detecting wifi

Postby Geeksquad9333 » Tue Jun 08, 2021 10:38 pm

I reinstalled windows on my HP laptop and the wifi worked for a few days (mind you i had to be literally right next to the Router) but then all of the sudden it cant detect any networks and even if i plug an ethernet cable in the little red x turns into a yellow triangle w/ an exclamation point and says connected but theres no internet.
Heres what ive tried
1. Going to network settings and disabling/enabling network adapters(NA)
2. Opening device manager and uninstalling drivers for NA and reinstalled them
3. Uninstalling the last windows update after it stopped working
4. Went into the laptop and disconnected the wires and disco nected and reconnected the wires on NA
5. Did a network reset
6. Reinstalled windows(again)
I was able to fix it by reading this post on HP deskjet 2652 wifi setup. After following the steps in this post I was able to fix this issue.
Geeksquad9333
Road To Glory
 
Posts: 115
Joined: Sat Apr 06, 2019 4:20 am
Location: united states

Re: Printer not detecting wifi

Postby Histar » Thu Nov 03, 2022 3:41 am

If the wifi is not working then you need to check your wired cable connection of the printer that is not detecting the power signal. Most people always prefer to get Cord cover wall for the wire cable that can protect your any kind of wired connection system.
Histar
Apprentice
 
Posts: 69
Joined: Fri Aug 09, 2019 3:34 am

Re: Printer not detecting wifi

Postby Monatyk » Mon Dec 12, 2022 8:38 am

The market for cryptocurrencies is at its most profitable and appealing right now, therefore it makes sense to invest in them. Since it is easy to use and enjoyable, I truly enjoy the game created by https://rollercoin.com/free-dogecoin where I can play and earn dogecoin. Try it, and you'll experience the same thing I did.
Monatyk
Road To Glory
 
Posts: 149
Joined: Wed Jul 03, 2019 12:40 am


Return to General Questions

Who is online

Users browsing this forum: No registered users and 10 guests

cron