Returns/parts broken

General 3D printing related questions, post here!

Returns/parts broken

Postby johnhowell » Fri Jul 22, 2016 6:29 am

Hello,

I tried printing from card and a couple problems happened: The test was just a giant mess of plastic that didn't look like anything, a giant glob of filament was at the end of the extruder and had to be cut off and while trying to cut off the glob i noticed the fan's struts were snapped. Should I return the whole unit, or can you ship me a new fan unit? My model is an Davinci jr. 1.0

Thanks,

John Howell
johnhowell
New Arrival
 
Posts: 1
Joined: Fri Jul 22, 2016 6:26 am

Re: Returns/parts broken

Postby sucre » Fri Jul 22, 2016 9:00 am

Hey,
I think the first need to do is to clean up the filament glob.
You can try use "Load Filament", when the temperature goes up to 190 degree, then kindly take out the filament glob.
For the fan issue,
1)If the fan is snapped but can still run, just take out filament glob and test printing again.
2)If the fan is broken, then you can release the 4 screws and take out fan, it won't influence your loading filament process.
Image
Image

Then please contact with customer service, if the printer is still under warranty, and if it belongs production issue, they'll help you to figure it out.

Please note, to do the Z-offset before printing, the bigger gap will cause the filament jammed.
Check here, http://forum.xyzprinting.com/viewtopic.php?f=30&t=49
sucre
New Arrival
 
Posts: 3
Joined: Fri Jul 08, 2016 1:13 pm

Re: Returns/parts broken

Postby soapandsoup » Wed Aug 03, 2016 10:58 am

Make sure that you clean your extruder really well before switching between PLA and ABS. If you don't, it tends to get clogged really easy. I found out the hard way.
soapandsoup
New Arrival
 
Posts: 7
Joined: Thu Jul 28, 2016 8:47 pm

Re: Returns/parts broken

Postby Jenette Moore » Wed Dec 11, 2019 10:41 pm

An organized form of the plant and substance is followed for the regular features for the turns. The nomination of the thesis rush is rushed for the officials. Acton is opened for the terms of the agents. The technique is formed for the width of the blog in themed of the classic use for the parts for the mid of the department.
Jenette Moore
New Arrival
 
Posts: 1
Joined: Wed Dec 11, 2019 10:40 pm


Return to General Questions

Who is online

Users browsing this forum: No registered users and 3 guests

cron