Prints Go Haywire after starting

[TinGeneral ]

Just started printing with my new pro. my prints ( even the demo's supplied by XYZ) start out fine then about half way through they become just random string and a ball of PLA. It is like it forgot what it was printing and just threw filament at it. Any suggestions on this problem?

[jason jason]

You may be suffering from layer shifting. Can you post a pic? Have you solved this? I will try to help, I need more info.

[txdo_msk]

Been a while since I printed, but when i was doing a lot, I kept getting spaghetti ptints whenever i had it down in my basement in Winter. Turned out it was too cold even for the enclosed space in my Jr W.

[jason jason]

If you have any more problems, pls don't hesitate to post again. Also if you find a solution, it's always helpful to post that answer, so that it may help others.

[BROOKEDAVIS]

Thanks for this article. I was wondering on Prints Go Haywire after starting is and William Jan Berry I was searching for it. I'm glad that I found this section. The sample and suggestions provided in this discussion helped me to understand it clearly.