davinci 2.0 filament issue

[DesRob5268]

I have been running my 2.0 duo for about 5 years strictly with abs filament. I went to switch to pla and cannot get it to extrude. It loads just fine but when I go to print, no filament comes out of the extruder. I have tried varying the temp from about 180c to about 210c with no improvement. Is this a problem with the 2.0?

[ducklife]

I am really happy to visit your blog. Now I have found what I really want. I check your blog every day and try to learn something from your blog. Thank you and waiting for your new post.
coloring pages

[Ned Orn]

The main problem was when you were trying to print something very big and it got stuck on the bed or froze. This happened many times and I am sure that it was not because of user error. I have addressed some solutions with the assistance of law dissertation service in this regard. The new version should have better electronics and hopefully, this will solve all of these problems.